Badge/Logo

admin | 30.11.2025

Loading 3D model...

LMB: Rotate | Scroll: Zoom | RMB: Pan

(0) 66 76

This badge/logo is suitable for 3D printing. If it's too large, you can cut it in half and add an additional support bar at the bottom.

Printing Recommendations:

Create small 1mm holes at the ends of the support rails as guides.
Use a 0.8mm drill bit for the holes to ensure proper printing.
After drilling, insert and cut paperclips to size, then secure them with superglue.
ABS plastic is recommended for printing.
If there is wear on the surface, consider sanding with a belt sander and then using wet 220 grit sandpaper for smoothing.

Thank you!