Binocular for modiFi helmet

This is another accessory for the modiFi helmet. It was inspired by the clone trooper helmet mounted binoculars as seen in Battlefront II. All parts shown in green on the first picture are included. Additional Parts needed: 2x M3x30 mm flat head screws - to assemble binocular (inserted on the front) 2x M3x5 mm flat head screws - for small knobs on the underside 4x heat set M3 inserts - for screws on binocular Visor made from clear tinted material (0,5-1 mm thickness recommended) 2x M4x20 mm flat head screw - to attach stalks to helmet 2x M4 nut (self locking) - to attach stalks to helmet 4x M4 washer 2x M4 spring washer - recommended for stalks Instructions: The level plates have an "O" for outside on one side, please place them accordingly. The visor sheet can be cut by hand or laser cut using the .dxf as template. The 3D file is only for reference and does not need to be printed. The stalks will benefit from using 100 % infill, the stalks are actually meant to be machined aluminium for better strength. If you have the option to get them made from something more sturdy than plastic it is recommended to do so. The stalks do not need to be attached to the binocular body in another way than placing it inside the recess on the inside. This way there is room for small shifts to allow for some tolerances during building. They get locked into position by sliding the top part of the binocular over them. Stalks should be attached to the helmet the following way: Screw -> Stalk -> Washer -> Level Plate -> Helmet -> Washer -> Spring Washer -> Nut The binocular uses the ear caps for standard rangefinders included in the helmet files. The binocular can be used in combination with the fin found here: https://www.thingiverse.com/thing:7186077 The helmet itself is a design sold here: https://fuacreations.etsy.com/de/listing/4382576753/custom-mandalorianer-helm-design-modifi Настройки печати и инструкции