Fiat 600 Gauge Holder

admin | 25.12.2025

Loading 3D model...

LMB: Rotate | Scroll: Zoom | RMB: Pan

(0) 22 22

This gauge holder fits standard 2" (52mm) gauges and replaces the ashtray in the Fiat 600.

Installation: Clip the holder into the dashboard where the ashtray was located.
Printing Settings: Print with the circular side down and supports. Recommended speed is 40mm/s for the outer wall and 25% infill.
Instructions: 1. Attach the gauge to the lid. 2. Clip the holder into the dashboard hole. 3. Run the wires through the holder to the gauge. 4. Use a small amount of glue to secure the lid to the holder, ensuring proper gauge orientation.

Note: It’s easier to connect the wire leads to the gauge before installation.