GT2 Hall Digital Tension Meter

admin | 02.01.2026

Previous model Next model

3D Preview

Loading 3D model...

LMB: Rotate | Scroll: Zoom | RMB: Pan

Gallery (10)

3D модель GT2 Hall Digital Tension Meter - фото 1

3D модель GT2 Hall Digital Tension Meter - фото 2

3D модель GT2 Hall Digital Tension Meter - фото 3

3D модель GT2 Hall Digital Tension Meter - фото 4

(0) 108 65

The GT2 Hall model is designed for measuring belt tension using a Hall effect sensor. Key components include:

Hall Sensor: SS49E
Digital Voltmeter: 0.36 inches, 3-wire (e.g., XH-028)
Magnet: 3x5 mm (can use 3x10 mm cut in half)
Cable: USB

Assembly steps:

Solder the sensor onto the voltmeter board, ensuring correct polarity.
Place the sensor centrally, opposite the magnet contact point.
The voltmeter should read around 2.4V without the magnet.

Attach the magnet if necessary. The magnet's orientation affects readings: one way increases the value, the other decreases. For accurate readings, a 10k resistor should be soldered between the input and common wire. This enhances the meter's sensitivity to slight tension changes.

Important: Adjust the belts to achieve consistent readings.