Mercedes W163 front tow hook cover

front bumper plugs. It is designed with all latches and fasteners included to securely fit into the stock hole. Technical features of the model: Compatibility: Mercedes-Benz W163 (ML230, CDI ML270, ML320, ML350, ML430, ML500, ML55 AMG). Note: Suitable for pre-restyling and restyled models (check that the bumper shape matches). Geometry: Fully matched to the curvature of the bumper for a perfect fit (flush). Fastening: Reinforced valve ears, which are less susceptible to fracture compared to fragile factory plastic. 3D Printing Recommendations: For exterior car parts, it is extremely important to choose the right material that is resistant to ultraviolet radiation and temperature changes. Material: ASA (the best option - does not fade in the sun) or ABS. You can also use PETG (if you plan to paint). PLA is not recommended because it warps when exposed to the summer sun. Seam height: 0.15 – 0.2 mm for a smooth surface. Infill: 20-40% (Tri-Hexagonal or Gyroid for strength). Orientation: It is recommended to print face up using internal mount supports to ensure the cleanest possible external surface. Advantages of using this model: Perfect fit: Model tested on real cars. Ready to Paint: After a light sanding and primer, the part is ready to be painted to match your car's color. Cost-effective: The cost of printing is several times lower than purchasing a new part. Advice for customers: Before installation, it is recommended to tie the cover with a thin plastic clamp or cable to the inside of the bumper through a special eyelet - this will ensure that you will not lose it again, even if the latches open.