3D Model of Truck Nutz for Your Vehicle

admin | 30.11.2025

Loading 3D model...

LMB: Rotate | Scroll: Zoom | RMB: Pan

(0) 42 15

This model is designed to hang from the rear bumper or trailer hitch to showcase the manliness of your truck, Jeep, or SUV.

Dimensions: approximately 5 3/4 inches wide at the widest point.
Printing recommendations: use a bed size of at least 150x150, 0.3 layer height, and 5% infill.
Mounting: require a 1/4" eye bolt with 2 nuts and a washer. The hole on the top is 6.5mm with an 11.5mm hex hole.
After printing, remove the model from the build plate. To secure the bolt, insert one nut inside, the washer and another nut on the outside, then thread the eye bolt through.
You can paint the model and attach it to your vehicle however you see fit.
ABS is recommended for outdoor use; if using PLA, make sure to spray paint it for UV protection.
Do not print them in LIME GREEN!