Pioneer DDJ-FLX4 Controller Stand Feet

These 3D-printed feet elevate your Pioneer DDJ-FLX4 by 4–5 cm and tilt it back by ~10° for better visibility and comfort during use.

• Advantages:
• Stable and non-slip design (pre-designed spots for 11.6 mm rubber pads)
• ~10° tilt angle for enhanced usability
• Quick installation: no glue or screws required
• Precise fit for the original Pioneer DDJ-FLX4
• Optional caps to cover overhang print lines

Included: both feet (left + right) placed side by side. Optimized print orientation. Recommended settings:

• Material: PLA or PETG
• Layer height: 0.2 mm
• Infill: 15% Gyroid
• Walls: 2
• No supports needed
• Print time: approx. 2.5–3 hours per foot
• Material usage: approx. 120 g per foot

Optional: small caps (separate 3MF file) can be glued into the recess to hide typical overhang lines. Tested with the original Pioneer DDJ-FLX4 controller. Note: this is a light elevation, not a replacement for large risers. Feedback, makes, and remixes are very welcome! Licensed under CC BY-NC-SA (attribution + non-commercial + share-alike). Happy printing!