Cover for Armrest Support on Fiat 500

This is the cover for the armrest support on the US 2013 Fiat 500 (and other models that use the same armrest mount).

Removing the armrest is simple: just push the seat material far enough to release the retaining clip. However, this leaves a hole in the seat with the post protruding about 20mm.

This solution uses the same mounting clip without causing permanent damage to the seat or armrest. Files are also included for just the connector in case you want to put something other than a dome there.

Keep in mind that you will still need to provide a hole for the stand (12mm diameter, 20mm deep). My structure is non-structural, so your print settings should not be structurally significant. Just print it out so it looks good enough for you.

I printed it in a 'mushroom' shape so that the 'bottom' would press against the seat. This way, I could have carelessly removed the supports, and the dome would still look decent even when printing quickly.