3D Model of Air Scoop with Larger Air Intake

admin | 01.12.2025

Previous model Next model

3D Preview

Loading 3D model...

LMB: Rotate | Scroll: Zoom | RMB: Pan

Gallery (3)

3D модель 3D Model of Air Scoop with Larger Air Intake - фото 1

3D модель 3D Model of Air Scoop with Larger Air Intake - фото 2

3D модель 3D Model of Air Scoop with Larger Air Intake - фото 3

(0) 114 67

Updated model with a larger air intake. Both 18" and 19" wheels are supported, along with smaller original brake calipers and larger brake kits.

Printing: Printing without supports is possible. Print the scoop with the air intake facing down towards the printer support plate! If the spatula doesn't fit, try positioning it at a 45-degree angle diagonally above the printing plate. Print one scoop as is for the left side and a mirror image for the right side.

Installation: Install the scoop as far from the center of the vehicle as possible. The closer to the wheel, the more space there is for the swivel wheel. Check out the photos above!

Note: For larger calipers in an upgraded brake kit, primarily used on the M2 Competition, swap the left and right scoops so that the air hose tube is closer to the car, and install the scoop as close to the car as possible rather than close to the wheel for smaller original brake calipers.