Bracket for Hyundai Veracruz Window Regulator

admin | 01.12.2025

Previous model Next model

3D Preview

Loading 3D model...

LMB: Rotate | Scroll: Zoom | RMB: Pan

Gallery (5)

3D модель Bracket for Hyundai Veracruz Window Regulator - фото 1

3D модель Bracket for Hyundai Veracruz Window Regulator - фото 2

3D модель Bracket for Hyundai Veracruz Window Regulator - фото 3

3D модель Bracket for Hyundai Veracruz Window Regulator - фото 4

(0) 101 43

This is a bracket that is part of the Hyundai Veracruz window regulator assembly. It may also fit other models. The factory part is too thin, leading to cable breakage and causing the window to fall into the door. This one is designed to be much stronger.

Instructions:

Print at 100% infill using a higher temperature material such as ABS.
Position the cable grooves vertically to ensure maximum sliding clamp strength on the opposite side.
A cobblestone rosette support is recommended, but block the supports inside the slot where the sheet metal tab goes through.
Soaking the part in acetone will also strengthen it.
If this part is broken, it is likely that the winch cables are frayed and need to be replaced. Use .062 cable as it is more flexible.
For attaching the cable, if a crimping tool isn't available, solder a lump of plumber's solder to it. Wrap a thin stranded copper wire around the cable where you want the drip to prevent it.
After the solder cools, file it down to smooth the adjacent surface.
Ensure that the other side has a small cutout for the metal tab, which needs to be added to the model.

Contact me if you need assistance.