Replacement Part for Infiniti "Push Button Clamps"

This is a replacement part for Infiniti push button clamps. I broke several of the original clips while removing the hood to replace the battery and created a new solution using Fusion 360. Recommendations:

• The original clamps in my car were nylon; I recommend using nylon if possible.
• I printed the spare parts using PETG. Consider them to be one-shots or with potential for multiple uses.
• There are two versions of the clamp retainer: one with slots for easier bending and the other without slots. Use the version without slots for nylon.
• This holding clip is designed for an 8mm diameter hole and can accommodate a depth of 5mm. Flange size is 20mm.

A 16mm flange version has been added for more sizing and scaling flexibility. The original Infiniti part number was 01553-09321, now replaced by 01553-2DR9A. This is a common retaining clip used in several places on these vehicles.