Wire Connector Replacement

admin | 03.12.2025

Previous model Next model

3D Preview

Loading 3D model...

LMB: Rotate | Scroll: Zoom | RMB: Pan

Gallery (1)

3D модель Wire Connector Replacement - фото 1

(0) 63 38

The only available replacement for this plug is a universal one costing $80. You can either reuse your connectors or purchase "fuse block connectors".

Others have successfully printed electrical connectors using PETG, but I opted for high-temp TPU. Be sure to apply a liberal amount of dielectric grease to prevent the connector from overheating again, and check it frequently for signs of overheating.

I only needed one, so I printed just one. If I did it again, I would stretch the overall length by about 1-2mm to better capture the terminals. This might be necessary with PETG. So far, it works fine in TPU.