KIA EV3 Centre Console Storage Box with lid and logo.

Printed with KIA and EV3 embossed on the inside of the lid. I would have put it on the top but that would make it a messy print. It needs a 3mm x 135mm rod (available from amazon or craft shops) for the hinge and then the rod-ends are simply glued onto the end of the rods after inserting into the hinge (obviously careful not to glue the lid half to the base half of the hinge). The pictures are of the prototype which fits nicely but needs a couple of changes to the material / slicer before the final item was made and is now fitted to the car. I needed to print it in PETG to stop it warping in the hot car during summer (currently in PLA for prototyping). I needed to print the lid with "ironing" on which will make the inside of the lid a bit smoother. I have printed in two colours because the Bambu P1S supports this but obviously it will still print in single colour but the embossing wont show as much. Inspired by but not a remix of https://www.thingiverse.com/thing:6886488 which I found didn't fit our EV3. Attaching to your car is your choice but I used velcro tape on the bottom of the base to make it removable and easy to take off the car if I need to. Настройки печати и инструкции