TTRPG Dice Print Settings

I created a set of TTRPG dice that can be easily printed on an FDM printer, featuring raised numbers with inset backgrounds. The design was made using the New Rocker font in DiceMaker. The plan is to paint the recessed areas of each die face, then sand away any excess to achieve a clean, high-contrast look. This method works with most filaments but tends to look best with lighter bases, such as white filament with red or black paint.

General Settings:

• Filament: PLA+ (regular PLA should work fine)
• No-brim
• Outer wall speed: 100
• Wall Loops: 2
• Quality Settings:
• Layer Height: 0.12mm
• First Layer Height: 0.12mm
• Seam Position: Nearest
• Precise Wall: Yes
• Only 1 layer on First Wall: Yes
• Supports: Yes
• Infill: 100%

Print Settings:

• First Layer Speed: 50mm/s
• First Infill Layer Speed: 80mm/s
• Number of Slow Layers: 40 (this can likely be tuned)
• Other Layers: 100mm/s

Support Settings:

• Supports Enabled
• Normal
• Auto
• On Build Plate Only
• Threshold Angle: 12°