Create Your Own Detailed Model of Destiny's Ghost Companion

admin | 05.12.2025

Previous model Next model

3D Preview

Loading 3D model...

LMB: Rotate | Scroll: Zoom | RMB: Pan

Gallery (14)

3D модель Create Your Own Detailed Model of Destiny's Ghost Companion - фото 1

3D модель Create Your Own Detailed Model of Destiny's Ghost Companion - фото 2

3D модель Create Your Own Detailed Model of Destiny's Ghost Companion - фото 3

3D модель Create Your Own Detailed Model of Destiny's Ghost Companion - фото 4

(0) 75 153

Create your own fully detailed model of Destiny's Ghost companion! This model is fully printable without supports. More details on printing can be found in the Instructions section.

There are 5 files for this model:

Black_Pieces.STL - Suggested Settings: Black PLA, 225°C, 15% fill, 2 shell, 0.12mm layer height, no supports.
Wing_Set.STL - Print two of these to make one model. White PLA, 225°C, 15% infill, 2 shell, 0.12mm layer height, no supports.
Diffuser_Ghost.STL - Transparent blue or aqua filament, 225°C, 15% infill, 2 shell, 0.20mm layer height, no supports.
Pins.STL - Any color, 0.2mm layer height, 2 shell.
Tips.STL - Orange PLA, 2 shell, 15% infill, 0.12mm layer height, no supports.

Wings have built-in rafts to help keep the corners stuck down. Trim these off afterwards with a deburring tool or razor blade. Use good super glue or 2-part epoxy to glue the neodymium magnets to the body and the inside of the wings. Pay close attention to the orientation of the magnets so that the correct sides attract each other; double-check this before gluing.

Tips should press fit into the tops of the wings. The black side wing inserts should slide onto the side wings and click into place, glue shouldn't be necessary. Glue the diffuser and black eye-cover onto the front of the body; they should fit snugly. Use pins to align the two halves of the main body. Apply a drop of glue to the holes first to permanently attach them.